Give a gift card. Let them choose their next make. Shop gift cards Skip to content

Change presser foot

Swap compatible snap-on feet. Shown on the Brother LX3817.

  1. 1Switch off

    Switch off

    Switch off. Switch off before changing the foot.

    Switch off before changing the foot.

  2. 2Raise the needle

    Raise the needle

    Raise the needle. Turn the handwheel toward you until the needle is highest.

    Turn the handwheel toward you until the needle is highest.

  3. 3Raise the foot

    Raise the foot

    Raise the foot. Lift the lever behind the needle.

    Lift the lever behind the needle.

  4. 4Remove the foot

    Remove the foot

    Remove the foot. Pull the foot straight down. Use the rear release button if fitted.

    Pull the foot straight down. Use the rear release button if fitted.

  5. 5Align the pin

    Align the pin

    Align the pin. Place the new foot’s crossbar directly beneath the holder’s notch.

    Place the new foot’s crossbar directly beneath the holder’s notch.

  6. 6Snap it in

    Snap it in

    Snap it in. Lower the lever. The holder snaps onto the crossbar.

    Lower the lever. The holder snaps onto the crossbar.

  7. 7Check the attachment

    Check the attachment

    Check the attachment. Raise the lever. The foot should lift with the holder.

    Raise the lever. The foot should lift with the holder.

  8. 8Check needle clearance

    Check needle clearance

    Check needle clearance. Select your stitch. Turn the wheel slowly; the needle must clear the foot.

    Select your stitch. Turn the wheel slowly; the needle must clear the foot.

Credits [2][4]