Ladder stitch
Fold inward and finger-press as you stitch. Pull the small stitches closed; score and iron near the end.
Fold both allowances inward on the sewing line and finger-press. From inside the right fold, bring the needle out at the first dot; hide the knot inside.
Cross the opening and pierce the matching first dot on the left, going from the printed outside into the fold.
Pull the doubled thread snug. This first rung sits at the corner, so it may not visibly close much of the opening.
From inside the left fold, bring the needle out through the very next black dot, including the small unlabelled dots.
Cross to the matching second dot on the right and push the needle from the printed outside into that fold.
Pull gently until these matching dots meet. Remove slack without puckering the fabric.
Come back out through the next black dot on the same right fold. After going into a fold, always come out at its next dot.
Alternate folds: travel inside a fold between consecutive dots, then cross to the matching dot.
More help
Alternate folds: travel inside a fold between consecutive dots, then cross to the matching dot. Tighten every few stitches; only a short ladder should remain loose. Refold and finger-press the next section as you go.
Shortcut: enter one dot on the right fold and bring the needle out through the next dot on that same fold. Pull the thread through.
Repeat the shortcut on the left fold. Enter one dot and come out through the next dot on that same fold.
Before the opening gets too small, ease the seam fully out from inside with the rounded bamboo spreader. Iron the edge, then finish closing it.
Continue to the end and connect the last matching dots across the opening. Pull the final corner rung snug.
Slip backward by one small dot inside the left fold. Pierce only this fold.
Cross to the matching dot on the right. Slip forward by one small dot inside that fold, returning to the final dot.
Slide the needle underneath the tiny stitch at the closed corner, keeping the needle out of the fabric.
Draw the needle and doubled thread under the corner stitch until a small loop remains. Stop before that loop disappears.
Pass the needle through the small loop at the end of the seam. Keep the loop open.
Bring the whole needle through the loop. Keep pulling toward the end of the seam.
Pull past the last dot, along the end of the seam. Seat the knot on the final stitch.
Use the clippers to trim both thread tails close to the secured knot, leaving the finished outside tidy.
Tips
1Tips 1
Stop every few stitches to tighten, refold and finger-press. Score from inside and iron near the end, before the gap becomes too small.
















