Change presser foot
Swap compatible snap-on feet. Shown on the Brother LX3817.
1Switch off
Switch off before changing the foot.
2Raise the needle
Turn the handwheel toward you until the needle is highest.
3Raise the foot
Lift the lever behind the needle.
4Remove the foot
Pull the foot straight down. Use the rear release button if fitted.
5Align the pin
Place the new foot’s crossbar directly beneath the holder’s notch.
6Snap it in
Lower the lever. The holder snaps onto the crossbar.
7Check the attachment
Raise the lever. The foot should lift with the holder.
8Check needle clearance
Select your stitch. Turn the wheel slowly; the needle must clear the foot.