Machine threading
Set up the Brother LX3817. Green shows the top thread; blue shows the bottom thread.
1Meet the machine
Find the parts used to thread and sew.
2Connect the pedal
Push the foot-controller plug into the socket on the right side of the machine. Put the pedal on the floor.
3Plug into the wall outlet
Plug the power cord into the wall outlet.
4Raise the presser foot
Lift the lever behind the needle to raise the presser foot.
5Raise the needle
Turn the handwheel toward you until its mark points up.
6Place bobbin on spool pin
Raise the spool pin and place a wound plastic bobbin on it. Let the thread unwind toward the top guide.
7Use the top guide
Draw thread from the upper bobbin through the rear guide, then toward the front groove.
8Down and around
Follow the right channel down, around the bottom, and up the left channel.
9Catch the take-up lever
Pass through the raised lever from right to left.
10Behind the needle guide
Bring the thread down behind the small guide above the needle.
11Thread front to back
Pass through the needle eye from front to back. Leave about 2 inches behind the foot.
12Open the bobbin cover
Keep the needle and foot raised. Slide the cover toward you and lift it off.
13Drop in the bobbin
Use a wound SA156 bobbin. Its thread must unwind counterclockwise.
14Follow the slit and cut
Hold the bobbin gently. Follow the slit under the spring, then pull toward the cutter.
15Close the cover
Seat the cover tab and close it. The quick-set bobbin is ready; no pull-up is required.
16Switch on
When threading is complete, press I on the power switch. The pedal controls sewing speed.
Tips
1Optional: leave a bobbin tail
To draw up the lower thread, reinstall the bobbin without cutting its tail. Leave the cover off.
2Catch the lower thread
Hold the upper thread. Turn the wheel toward you one full turn; pull up the bobbin loop.
3Tails toward the back
Put about 4 inches of both threads behind the raised foot. Replace the cover.